EXaminer® | CUI 310 E NB

(No reviews yet) Write a Review
SKU:
17-2131-**** / ****
International HazLoc Rating:
Zone 1
Adding to cart… The item has been added

Product Overview

Description

Corrosion under insulation (CUI) is one of the costliest and unavoidable problems facing the hydrocarbon processing industry today. CUI affects the steel piping, storage tanks, container vessels and other process equipment within the plants that are subject to extreme temperature fluctuations.

Insulation applied to the pipe can mitigate the thermal cycling effects. But the presence of seams, gaps or other discontinuities in the protective cladding or in the insulation layer makes them susceptible to infiltration by outside humidity or from the process environment itself.

The Wireless CUI sensor will report actual temperature, relative humidity and direct water presence from the section of the process pipe. These data can then be stored and analyzed in a IoT dashboard, to monitor status, show trends and adjust the nessesary service/maintanance intervals. With use of the CUI sensor you can pay attention to most critial parts of the pipeline, as well as reduce HSE risk for the physical worker in the hazardous area. Inspection in dry areas can be acoided or postponed. This will give you the oppurtunity to go from a reactive maintainance plan to a preventive and predictive method, which will also be cost saving over time.

Features

  • Low Power device based multi-protocol SoC
  • Communication Narrow Band IoT, LTE-M
  • Relative humidity range 0 – 100 %RH
  • Temperature range -40 to + 80 °C
  • Direct water presence detection, capacitive sensor
  • Housing in UV stabilized POM
  • IP67 according to IEC 60529
  • Developed for robotized installation
  • Disposable cutting tool for stainless steel integrated in the sensor
  • The technology is Patent pending; comprising the sensor design combining cutting/drilling and fixation in one operation, prepared for robotized installation
  • The sensor is powered from two 3V Lithium Manganese Dioxide batteries in series.
  • Expected battery life: 9-11 years (0 - 40 °C, hourly measurements, daily transmissions). Lifetime is influenced positive and negative depending on environmental conditions as well as measurement and transmission intervals.

Explosion Protection

Marking

Ex II 1G Ex ia IIC T4 Ga -40 °C≤Ta≤+80 °C

IECEx

IEC 60079-0:2017
IEC 60079-11:2011

Certification

ATEX Directive
2014/34/EU

EN IEC 60079-0:2018
EN 60079-11:2012

Certification

EU - Radio Equipment
Directive 2014/53/EU

ETSI EN 301 489-1 V2.1.1
ETSI EN 301 489-17 V3.1.1
ETSI EN 300 328 V2.1.1

DATA SHEET

Installation Guide

Reviews

(No reviews yet) Write a Review